2 Protection Circuitry
TOP PREVIOUS NEXT
The protection circuitry may have operated if either of the following conditions is noticed:
No sound is heard when the power is switched ON.
Sound stops during a performance.
The functions of this circuitry is to prevent circuitry damage if, for example, the positive and negative
speaker connection wires are shorted, or if speaker system with an impedance less than the indicated
rated impedance of this unit are used.
If this occurs, follow the procedure outlined below.
1. Switch OFF the power.
2. Determine the cause of the problem and correct it.
3. Switch ON the power once again.
Note:
When the protection circuitry functions, the unit will not operate unless the power is first switched
OFF and then ON again.
•@
TOP PREVIOUS NEXT
To Next Page
Loading...
