97
USB Over Current Error
• USB device is drawing too much power.
Disconnect the USB device and turn the unit to
standby and on again. (⇒ 49)
Wi-Fi Setup
• Select “On” and press [OK] to enter the network
setting. (⇒ 28)
To exit the network setting, select “Off” and
press [OK].
Hub Device Not Supported/Not Supported/
Device Not Recognized/
USB Device Not Supported
• The connected USB device is not supported.
• The format of the file on the USB device is not
supported.
For supported formats, refer to “File format”
(⇒ 107)
To Next Page
Loading...
