24
RQT5744
Timer operations
Using the timers
Checking the timers
Press [CLOCK/TIMER] to select “z PLAY” (or “z REC”).
The timer conditions are shown in the following order:
Start time / finish time / source / (“z PLAY” only) volume
The timers can be checked even if the unit is off.
Playing the unit after the timers are set
The unit can be used after the timers are set. Make sure the unit is
off before the set start time.
Turning the timers on and off
The timers come on at the set time if the [z PLAY/z REC] indicator
is on. Turn them on and off by pressing [z PLAY/z REC]
(a pages 22 and 23).
If the unit is turned off while a timer is functioning, the finish time
setting will not be activated.
Note
B
A
The play and record timers
Remote control only
This timer turns the unit off after a set time.
While playing a source
Press [SLEEP] to select the time (minutes).
Each time you press the button:
To cancel the sleep timer
Press [SLEEP] to select “SLEEP OFF”.
“SLEEP” goes out.
To confirm the remaining time
(While the timer is functioning)
Press [SLEEP].
The remaining time is shown for about five seconds.
To change the setting
Press [SLEEP] to display the remaining time, then press again to
select the required time.
The sleep timer is canceled if CD editing is started.
Note
The sleep timer
C
Any of the timers can be used together, but ensure the unit is off
before the start time for the record and play timers.
Using the timers together
z PLAY/z REC
A
To Next Page
Loading...
Need help?
General
