33
RQT5479
Recording operations
Recording discs
The unit calculates the length of the tape and decides which tracks
go on which side of the cassette so tracks are not cut off midway.
Preparation: Do the preparatory steps (
a
page 31).
Select DVD as the source with [INPUT SELECTOR].
Insert a CD.
Press [AI EDIT].
The unit makes the calculations and “AI EDIT TAPE” scrolls across
the display. It takes a moment for recording to start.
After the deck completes recording the CD
It goes into recording standby mode. If there is space left on the
tape, “LINK” and the remaining time on the tape flash on the
display.
¡If you have completed recording, press [ ] on the deck or the
DVD Audio/Video player.
¡If you wish to continue recording with another CD, see “Linking”
below.
To stop editing
Press [ ] on the deck or the DVD Audio/Video player.
“EDIT OUT” is displayed and both sections stop.
When tracks are allotted to both sides
When the tracks allotted to side A finish playing, the deck records to
the end of the side to complete calculation.
Editing programmed tracks
Program the tracks (
a
steps 1,2 and 3, page 27) and press [AI
EDIT].
Tracks numbered 25 or over cannot be recorded by one touch
editing. Use normal recording (
a
page 32).
Note
One touch CD editing (AI EDIT)
A
Linking
If “LINK” is flashing and you wish to continue recording from another
CD, do the following.
1 Press [ OPEN/CLOSE] and insert
another CD.
Press [ OPEN/CLOSE] to close the tray.
2 Press [
uu
] on the DVD Audio/Video
player.
Recording begins again.
You can continue linking tracks as long as there is space on the
tape. If you load a CD that has no tracks short enough to fit in the
remaining space, linking cannot be done.
To cancel
Press [ ] on the deck or the DVD Audio/Video player.
“EDIT OUT” scrolls across the display.
Linking programmed tracks
Program tracks after inserting the new CD (
a
steps 1, 2 and 3,
page 27).
B
To Next Page
Loading...
