Checking the timers
Press [CLOCK/TIMER, –DEMO] to select “ PLAY” (or “ REC”)
The timer conditions are shown in the following order:
Day → times → source → (“ PLAY” only) volume
The timers can be checked even if the unit is off.
Playing the unit after the timers are set
The unit can be used after the timers are set. Make sure the unit is
off before the set start time.
¡If the unit is turned off while a timer is functioning, the finish time
setting will not be activated.
¡The timers (either one or both) are set when the “ PLAY/
REC” indicator is on.
Note
The play and record timers
Remote control only
This timer turns the unit off after a set time.
While playing a source
Press [SLEEP] to select the time (minutes).
Each time you press the button:
To cancel the sleep timer
Press [SLEEP] to select “SLEEP OFF.”
“SLEEP” goes out.
To confirm the remaining time
(While the timer is functioning)
Press [SLEEP].
The remaining time is shown for about five seconds.
To change the setting
Press [SLEEP] to display the remaining time, then press again to
select the required time.
The sleep timer is canceled if one touch editing is started.
Note
The sleep timer
Any of the timers can be used together, but ensure the unit is off
before the start time for the record and play timers.
Using the timers together
A
B
To Next Page
Loading...
