Technics SE-CH530 - Page 5

SE-CH530
s
. e
Adhesive tape :
;
s
s
s
2
*
*
a
a
s
*
e
e
s
.
i
*
.
a
FM indoor antenna (included) <
:
;
>
»
s
. 7
*
.
eT er ee er a a te Tee a re ee ee ee
e
;
For others ;
:
*
*
1]
:
e
s
2
Strip off the outer covering.
esos evaseeeeacascaeoeeoeeoe ee eae
Insert the wire.
Se eoe er eeeseecseasaeeseeseeeeaescseseseoesse ees eect seateeeoeeeeeetcceetseb
2 Connect the FM indoor antenna. 3 Connect the AM (MW/LW) loop antenna.
The tip of the internal antenna wire should not come into . Attach the antenna holder to the rear panel of the
contact with any metal objects. tuner/sound processor. Press the antenna holder hard
enough to get it fixed firmly in the place, with a click.
2. Clamp the antenna with its cord come upward to the an-
When you cannot get a good reception of FM radio broadcast: tenna holder.
einstall the antenna on a wall at a height and in a direction 3. Connect the antenna terminal to the rear panel of the
which result in the best reception. tuner/sound pocessor.
eWhen you cannot get a good reception with this FM indoor
antenna, we recommend you install an FM outdoor antenna
(not included).
eWhile listening to an MW/LW broadcast, position the loop
antenna for the best reception.
For areas except Continental Europe: EJ
You may attach the antenna holder to a rack Or other structure.
Use a screw (included) to attach as shown in the figure. FJ
To minimize noise pickup, bundle the loop antenna Cord using a tape
or so to keep the flat cables away from the AM loop antenna cord...