Technics SE-CH610 Service Manual

SE-CH610
ee aun DCC (not included)
(Red)
te)
DCC
REC PLAY
(OUT) (IN)
oe
©) @
ee
Tuner/sound processor
Analog player (not included)
“LINE OUT"
Tuner/sound processor
eee theate Stel oh
External unit connection Analog player
This example shows how to connect the analog player with the
eFor details, refer to the Operating Instructions of the units which PHONO OUT/LINE OUT switch.
are to be connected.
eWhen units other than those described below are to be connected,
please consult with your audio dealer Only an analog player with a built-in phono equalizer can be con-
nected.
Set the LINE OUT position at the back of the anal layer.
Connecting
the
stereo
connection
cable
(not
included)
EJ
p
analog
pray
Connect the red plug to the right (R) connector.
Connect the white plug to the left (L) connector.
DCC (digital compact cassette deck) B
@ Location of Controls
@ Power “STANDBY (5/ON” switch
(POWER, STANDBY (/ON)
Press to switch the unit from on to standby mode or vice versa. In
standby mode, the unit is still consuming a smal! amount of
power,
@ Standby indicator (STANDBY)
When the unit is connected to the AC mains supply, this indicator
lights up in standby mode and goes out when the unit is turned
on.
@ Display section
Power meter display shows the left and right output level.
) Volume control
© Headphones jack © 3.5, 32 2
© Microphone jack(s) @ 6.3, 600 Q
@ Microphone volume control

Technics SE-CH610 Specifications

General

Brand	Technics
Model	SE-CH610
Category	Amplifier
Language	English