6.1.1 Automatic Adjustment Results
TOP PREVIOUS NEXT
1. Turn on the power.
2. Load the test disc (SZZP1054C).
3. Hold down the REPEAT button for at least 2 seconds, and then press the STOP button for at
least 2 seconds while continuing to hold down the REPEAT button.
4. A servo section error code is displayed. Refer to
Error code based on troubleshooting . Use
this error code display as a guideline for finding the malfunction point in the servo circuitry. If
the errorcode E00 is displayed, the unit is OK.
•@
TOP PREVIOUS NEXT
To Next Page
Loading...
