Technics SL-P202A - Page 2

SL-P202A
m PLACEMENT
Before placement
Two transport security devices are secured to prevent the optical
pickup from damage during transport.
Be sure to release them before use.
RELEASED
LOCKED
i
(C ©)
U
(with
inclination!)
Insert them here after removing.
Turn clockwise by 90° to secure
them.
Soft cloth or similar material (to
prevent scratches)
Note:
When transporting the unit, be sure to remove the compact disc
from inside the unit. And replace the transport security devices
again following the reverse order not to damage the optical pickup.
(Make sure to place the unit with the rear panel facing downward.)
m ACCESSORIES
@AC power supply cord .. 1
SJA187 (E, EG, EB, EH, EF, Ei)
SJA193 (EK)
Notes of placement
@ Piace on a flat, level surface so that the front-rear
inclination does not exceed 5°.
@ Avoid places such as the following:
Near any equipment or device that generates strong magnetism.
On any heat-generating. equipment or device, or in any place
where the temperature is high (40°C or higher).
Extremely cold places (5°C or below).
eNear a tuner or TV (it may cause noise in the broadcast, or
disturbance of the TV picture.)
™ Do not place heavy objects, other than system compo-
nents, on top of the unit.
@ When carrying or storing the unit, handle it with care so it is
not subjected to any strong bumps.
Always remove the disc before storing the unit for any period of-
time.
@ To avoid problems due to vibration.
Do not place a book er similar object under this unit.
©Do not route the connection cables (of this or other units) across
the operation panel, across the top, or under the unit.
Stereo connection cable
(SJP2249—3)
Note: Configuration of AC power supply cord differs according to area.