Technics SL-P202A - Measurements and Adjustments; Adjustment Points

. | surz02a
m MEASUREMENTS AND ADJUSTMENTS
Caution:
It is very dangerous to look at or touch the laser beam. (Laser radiation is invisible.)
With the unit turned ‘‘on’’, laser radiation is emitted from the pickup lens.
Avoid exposure to the laser beam, especially when performing adjustments.
[ PREPARATION |
. Remove the cabinet (see Ref No. 1 of the disassembly instructions.)
. Remove the disc holder (see Ref No. 6 of the same).
. Place the test disc on the turntable.
. Turn ON" the power switch at the player.
Push the bracket of tray SW (S1001) in the direction of the arrow
and release it.
OpRWNR
Disc
lid
Note: If the test disc fails to rotate, press the tray switch again.
Test disc
ADJUSTMENT POINTS
e Servo P.C.B. @ Main P.C.B.
Laser power adj. Focus offset adj. Servo LINE OUT
P
VR3520 VR3569
R3501
(Resistor)
R3562
(Resistor)
Main P.C.B.
ee