Technics SL-P202A - Page 10

SL-P202A
| Ref. No.
9 How to remove the servo P.C.B. | o @ e
Procedure ¥
122-5 : Servo P.C.B.
+679
Connector
(No. 32)
1. Remove the 4 screws (Q@~@).
2. Remove the FPC board from the optical pickup.
3. Remove the connector (Ref. No. 32) of the
turntable motor.
Caution: To prevent the breakdown of the laser
diode, antistatic shorting pin is inserted
into the FPC board.
FPC board
Ref. No.
10
How to remove the loading motor 11 How to remove the optical pickup unit
Procedure 1. Remove the drive belt.
1+6-10 2. Release the clamping spring.
3. Unsolder the 2 terminals of the lead
wire of the loading motor.
Procedure
125-6
79-11
1. Remove the 4 screws (@~Q).
2. Remove the FPC board from the optical pickup.
4)
0
ae Optical pickup unit &
ay
ae
|e
FPC board
Ref. No. How to remove the power supply
| 12 P.C.B.
Procedure 1. Remove the 4 screws (@~Q).
1-612 2. Remove the connector (CN1).