Technics SL-P202A - Page 9

SL-P202A
-
Procedure
1-2-+5-6
Ref. No.
8
Procedure
1-7-8
Screwdriver
1. Pull the disc holder slowly in the direction
of the arrow until the disc tray comes up.
2. Pull the disc holder until it stops.
3. Push the bracket of tray SW (S1001) in the
direction of the arrow.
. Pull out the disc holder further to remove it.
. Set the power switch in the “OFF” position.
. Remove the power switch rod by using a
screwdriver.
(] Bracket
[|] of tray
SW ($1001)
A
B. Power switch
1
2
LP
Power
switch
rod |
| | q
:
Hl Disc
—— holder
Disc tray |
aa
How to check the servo P.C.B.
¢ When checking the soldered surfaces
of the servo P.C.B. and replacing the
parts, do as shown below.
Note: Insert the loading unit into the tabs of the
front panel, (Fixed loading unit)
Loading unit
Front panel
Ref.
No.
How
to
remove
the
disc
holder
and
power
.
:
6
awitchrad
How
to
remove
the
loading
unit
A.
Dise
holder
Procedure
1+2+5
+67
1. Remove the 3 screws (Q@~ @).
2. Remove the 2 connectors (CN12, CN401).
(To play a disc}
1. Place the test disc.
2. Turn “ON” the power switch of thepla yer.
3. Push the bracket of tray SW ($1004) in the
direction of the arrow and release it
Note: If the test disc fails to rotate, pressthe tray
switch again.
Ae
rar, |