Technics SL-P202A - Page 8

SL-P202A
How to remove the main P.C.B. |
How to check the main P.C.B.
Procedure
When
checking
the
soldered
surface
of
the
main
1-2-+3
1.
Remove
the
4
screws
(@~@).
P.C.B.
and
replacing
the
parts,
do
as
shown
below.
+4
2.
Remove
the
3
connectors
(CN11,
CN12,
1.
Connect
the
main
P.C.B.
ground
terminal
(LINE
CN401). OUT terminal) to the chassis with a lead wire.
3. Lift the main P.C.B. off the retention 2. Connect the operation P.C.B. ground terminal to
posts on the chassis. the chassis with a lead wire.
4, Remove the main P.C.B. in the direction
of the arrow.
Lead wire
Lead wire
Procedure
1-5
1. Remove the spring.
2. Pull out the disc lid in the direction of the arrow.
3. Push the 2 claws in the direction of the arrow.
Caution: Be sure to handle the small bali
carefully.