Technics SU-A600 Operating Instructions

Remote Control Transmitter
SU-A700 only
Insertion of remote control transmitter batteries
1. Open the cover.
2. Insert the batteries.
• Be sure to insert according to the
(+) and (-) Indications in the
battery compartment.
• Use two UM-4, "AAA” R03 (1.5 V)
size batteries. /
3. Close the cover.
■ Battery life
Battery life is about one year. (Battery life
may vary depending upon the frequency of
use and other conditions of use.)
The batteries should be replaced If the unit
cannot be operated even when the remote
control transmitter Is brought close to the
unit.
■ Battery notes
• Be sure that batteries are inserted so that
they are placed correctly with respect to
the (+) and (-*) indications in the battery
compartment. If the batteries are not In¬
serted correctly, they may leak and
damage the remote control transmitter.
• Do not use rechargeable (nickel-cadmium)
type batteries.
• Do not mix old and new batteries, or bat¬
teries of different types (such as carbon
and alkaline.)
• If the remote control transmitter is not to be
used for a long period of time, take out the
batteries and store them in a cool, dark
place.
• Remove and dispose of worn-out batteries.
• Never attempt to recharge or short-circuit
the batteries, and do not disassemble them
or expose them to excessive heat or throw
them Into a fire.
• If a battery leaks, remove both batteries
and dispose of them, and then thoroughly
clean the battery compartment before in¬
serting new batteries.
Remote control transmitter operation notes
Face about 7 meters In front of
the sensor.
(This actual range will depend on the
angle at which the remote control is
used.)
©©•© e&esfi
A
30°
V
m \
13CT
i
Be sure the transmitter part of the remote control
transmitter and the receptor part of this unit are
free from dust.
Excessive dust might prevent reception.
^§@© ■ 0 Aeeaa
Avoid dust
Avoid dust
-Other notes-
1. Do not expose the receptor (on this unit) 2.
to direct sunlight or other strong light,
because to do so might result in Incorrect
operation.
Do not use a remote control transmitter 3.
for a TV set, a VCR or other video compo¬
nent at the same time as this remote con¬
trol transmitter is being used, because to
do so might result in Incorrect operation.
If this unit Is installed in a rack with glass
doors, the glass door’s thickhess or color
might make it necessary to use the
remote control transmitter a shorter
distance from the unit.
11

Technics SU-A600 Specifications

General

Input Sensitivity	2.5mV (MM), 150mV (line)
Speaker Load Impedance	4Ω to 16Ω
Type	Integrated Amplifier
Dimensions	430 x 134 x 315 mm
Damping Factor	60 (8 ohms)