Technics SU-A600 Operating Instructions

Remote Control Operation
SU-A700 only
• This remote control transmitter can be used to operate CD
players and tape decks which are equipped with remote control
terminals or remote control sensors, or to operate tuners which
are equipped with remote control sensors.
Consult your dealer for details.
• For detailed information concerning operation steps, etc.,
please refer to the appropriate page for each unit and the
respective operating instructions.
• Make sure that the power of each unit is set to the "ON” posi¬
tion before beginning the operations.
NOTE:
Face this remote control transmitter toward the main unit to
operate the main unit or other units which are connected to
the main unit by means of a remote control cable (See page
5).
To operate any other unit, face this remote control transmitter
toward that unit.
To operate the amplifier
To select an input source
AUX CO TUNER PHONO
o o o o
TAPE 1 TAPE 2
o o
To adjust the volume level
VOLUME +
CUD
To listen to radio broadcasts
To select the desired channel sequentialy
S' /\
PRESET O CD
Select the desired
preset channel.
To select the desired channel directly
i wen
O *
2
o
3
0
4
o
6
0
7
0
6
o
0
O 5
Specify the preset channel
Example: Channel 12
. i’O 1 2
lO « ► O *OJ
To select the desired band
TUNER
o *
txsc/BAND The band changes
each time the
button is pressed.
12

Technics SU-A600 Specifications

General

Input Sensitivity	2.5mV (MM), 150mV (line)
Speaker Load Impedance	4Ω to 16Ω
Type	Integrated Amplifier
Dimensions	430 x 134 x 315 mm
Damping Factor	60 (8 ohms)