Technics SU-G700 Owner's Manual

23
English
Using analog audio input device
Operations
(23)
Analog audio cable (not supplied)
CD recorder, etc.
You can connect the CD recorder, etc. with analog
audio cable (not supplied) to output analog audio
signals from this unit (LINE1/LINE2/PHONO).
Using analog audio cable
1 Disconnect the AC power supply cord.
2 Connect this unit and a CD recorder,
etc.
3 Connect the AC power supply cord to
this unit. ( 15)
4 Press [AMP
] to turn this unit on.
Note
• When a digital audio signal (COAX1/COAX2/
OPT1/OPT2/PC) is selected as input source of
this unit, analog audio signal (LINE1) is output.
• The choppy audio occurs in output audio signal
when switching the input source.
Do not input the audio signal from PRE
OUT/LINE OUT terminals to the analog
audio input terminals of this unit. Doing so
may cause malfunction.

Technics SU-G700 Specifications

General

Type	Integrated Amplifier
Power Output (8Ω)	70 W + 70 W (1 kHz, T.H.D. 0.5%)
Power Output (4Ω)	140 W + 140 W (1 kHz, T.H.D. 0.5%)
Input Sensitivity/Impedance Line	200 mV / 47 kΩ
Input Sensitivity/Impedance Phono	2.5 mV / 47 kΩ
Speaker Impedance	4Ω - 16Ω
USB-B Input	Yes
Coaxial Input	1
Standby Power Consumption	0.3 W
Weight	12.3 kg
Signal-to-Noise Ratio Phono	83 dB (IHF-A)
Digital Inputs	Coaxial, Optical, USB-B
Analog Inputs	1 (Phono)
Analog Outputs	1 Line
Dimensions	430 x 148 x 428 mm