TechniSat DIGIPLUS UHD S - Page 100

100
> Use the right/le arrow buons to highlight Yes or No and confirm using
the OK buon. Depending on your selection, the changes will now be saved or
rejected and you return to the next menu level up.
Alternatively:
> Press the Menu or TV/RADIO buon to leave the menu directly. Seings that
need to be saved manually will be reset in this case.
If the green function buon with Accept is not displayed on the boom line of
the screen, the changes are saved automatically on exiting the menu.
By pressing the TV/RADIO buon, you always return to normal TV mode
without saving if you are in a menu.
9.4 Changing a seing
You can create seings using the arrow selection method, the selection list, by
entering numbers and by using the virtual keyboard. The device specifies the
method that can be used to change a highlighted seing. This is evident from the
following displayed symbols:
- Arrow selection method (Section 9.4.1)
Arrows are shown on the le or right edge of the highlight.
- Selection list (Section 9.4.2)
Symbol is shown on the right edge of the highlight.
- Entering numbers (Section 9.4.3)
- Virtual keyboard (Section 9.4.4)
Symbol is shown on the right edge of the highlight.
9.4.1 Arrow selection
> If is shown on the le and on the right next to the set value, you can alter
this using the le/right arrow buons.