89
DE
EN
4.3 Periods of non-use
During a storm or lengthy periods of non-use (for example holidays), the device
should be disconnected from the mains and the antenna cable removed.
Before you disconnect the receiver from the mains, you should first switch it to
standby mode and wait until the red LED light is displayed.
4.4 Important notes on operation
Operation of the device is simplified through the use of so-called "On Screen
Displays" (OSD). This also means that the number of keys on the remote control unit
is reduced.
All functions are displayed on screen, and can be controlled by means of a few
control buons.
Functions that are logically related are combined into a "MENU". The selected function
will be highlighted. The red, yellow, blue and green function buons are indicated
by coloured bars at the boom of the screen. These coloured bars represent
dierent functions in the various menus, which can be implemented by pressing
the appropriately coloured buons (multi-function buons) on the remote control.
The function buons are only active when a brief description is displayed in the
appropriate field.
The buon identifications and terms that appear in the OSD menu are shown
inboldtype in this operating manual.
Help: where available, press the blue function buon in the menus to display the
help text; press again to close the help window.
The illustrations (screenshots) in this manual are to be seen as an example of
use and to illustrate basic operating steps. They may dier depending on the
device soware used.
4.5 Important information on data security
Before handing your device to your supplier for maintenance purposes, we
recommend that you remove all USB storage media.
The recovery of data is not part of the maintenance and repair work. TechniSat
assumes no warranty for the loss or damage of data during the repair.
To prevent data loss, you should back up your data from time to time.
To Next Page
Loading...
Need help?
General
