TechniSat DIGITRADIO 3

71
DE
EN
FR
NL
8.7 Saving FM stations to a memory slot
The station memory can save up to 20 stations within the FM range.
> First set the desired station frequency (Section 8.3, 8.4)
> In order to store this station on a memory slot, hold down the FAV buon
during playback until [Favourite memory] appears in the display. Then use
the <, > buons to select a favourite memory slot (1...20). Press the OK buon
to save.
> Repeat this process to save additional stations.
You can also save stations to one of the numeric keypad keys by holding
down the corresponding buon a lile longer. The same applies to the direct
selection buons on the device.
8.8 Retrieving FM stations from a memory slot
> To call up a station that you have stored in the FAV memory slots, briefly press
the FAV buon and select a station slot (1...20) using the <, > buons. Press
the OK buon to play the station.
If no station is saved in the selected station slot, [(empty)] appears on the
display.
Alternatively, you can also use the relevant numeric key on the remote control
or the direct selection buon on the device.
8.9 Overwriting/deleting a station memory slot
> Simply save a new station to the respective memory slot as described.
When restoring the factory seings, all memory slots are deleted.
9 Bluetooth
In Bluetooth mode, you can enjoy music from a connected smartphone or tablet via
the DIGITRADIO 3's speakers. To do so, the two devices must first be "paired" to each
other.
9.1 Switching on Bluetooth mode
> Change to Bluetooth mode by pressing the MODE buon.
> [Bluetooth] is shown on the display.
When switching on for the first time, an external device (smartphone / tablet)
must first be paired.
BDA_DIGITRADIO_3_V11.indd 71BDA_DIGITRADIO_3_V11.indd 71 10/11/2020 09:4510/11/2020 09:45