TechniSat DIGITRADIO 3

70
8.3 Automatic station scan
> Hold down the P+ or P- buons for 2 to 3 sec. to automatically search for the
next station with a sucient signal.
> Alternatively, you can also press the OK or SCAN buon.
If an FM station with sucient signal strength is found, the scan stops and the
station is played. If an RDS station is being received, the station name appears
and, possibly, the radio text.
Please use the manual station scan to set weaker stations.
8.4 Manual station scan
> Briefly press the P+ or P- buons repeatedly to set the desired stations or
frequency.
The display shows the frequency in increments of 0.05 MHz.
8.5 Scan seings
In this menu item it is possible to set the sensitivity of the scan.
> Press the MENU buon and use the < or > buons to select the [Search
seings] item, then press the OK buon.
> Select whether the scan should only stop for stations with a strong signal
[Strong Stations Only] or for all stations (including stations with a weak
signal) [All Stations].
With the All Stations seing, the scan stops automatically upon detecting
each available station. This can result in weak stations being played with
background noise.
8.6 Audio seings
> Press the MENU buon and use the < or > buons to select the [Audio
seings] item.
> Press the OK buon.
> Use < or > to select the [Stereo available] or [Mono only] item to play back
audio in stereo or in mono only if FM reception is weak.
> Confirm by pressing the OK buon.
BDA_DIGITRADIO_3_V11.indd 70BDA_DIGITRADIO_3_V11.indd 70 10/11/2020 09:4510/11/2020 09:45