The supplied radio holder can be attached in various ways:
1.
With the 2 screws supplied (use the holes on the frame of your bike for the bottle
cage).
2.
Using the supplied straps at any point on the frame. To do this, first attach the
rubber strip under the radio holder to protect the frame from scratches or
damage.
3.
A combination of screws and belts, depending on the position.
Even if the DIGITRADIO Bike 1 is installed correctly, it is possible, especially
when travelling over very rough terrain, that the DIGITRADIO Bike 1 may fall
out of the holder. Therefore, if possible, secure it additionally against falling out.
To Next Page
Loading...
