EasyManuals Logo

TechniSat Switch Series User Manual

TechniSat Switch Series
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
7
WARNING
Do not open the device under any circumstances!
Touching parts that conduct voltages can be fatal!
Observe all of the following instructions on the intended use of
the device and to prevent device defects and personal injury.
- Do not repair the device yourself. Repairs may only be carried out
by trained specialists. Contact our customer service department.
- The device should only be operated under the intended
environmental conditions.
- Do not expose the device to dripping or splashing water
(protection class IP20). If water has penetrated the device, switch
it o and inform the service department.
- Do not expose the device to heat sources which could heat it up
more than normal use will.
- In the event of an obvious device defect, the production of an
odour or smoke, significant malfunctions, or damage to the
housing, notify the service department immediately.
- The device must only be connected to a mains voltage of 230 V~,
50 Hz (+/- 10 %). Never try to operate the device at a dierent
voltage.
- If the device shows signs of damage, it must not be put into
operation.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the TechniSat Switch Series and is the answer not in the manual?

TechniSat Switch Series Specifications

General IconGeneral
BrandTechniSat
ModelSwitch Series
CategorySwitch
LanguageEnglish