57
DE
EN
13 Shutdown and re-start of the charging station
The TECHNIVOLT charging station does not have its own mains switch.
The charging station can be taken out of service temporarily or for the long-term if required.
Carry out the following steps:
1. Switch o the upstream line protection switch.
2. Switch o the upstream residual current device.
The charging station is now not able to carry out any charging processes. You can now carry
out electrical dismantling.
Carry out the following steps to put the charging station back into service:
1. Switch on the upstream line protection switch.
2. Switch on the upstream residual current device.
The charging station is now being supplied with power. The charging station can be used for
charging electric vehicles again aer the internal charging controller has booted up.
Electrical dismantling must always be carried out by a qualified electrician.
14 Disposal
Electronic devices do not belong in the household waste and must be disposed of properly in
accordance with Directive 2002/96/EC OF THE EUROPEAN PARLIAMENT AND COUNCIL dated
January 27, 2003 concerning waste electrical and electronic equipment. Please return this device
to the designated public collection point for disposal at the end of its service life.
The symbol on the device indicates this requirement.
DANGER
Danger to life from electrical power.
There is an immediate danger to life by electrocution if you touch live parts.
De-energise the installation before starting work.
Observe the 5 safety rules to prevent electrical accidents.
• Release.
• Secure against restarting.
• Validate that the power is o.
• Earth and short-circuit.
• Cover or cordon o any adjacent live parts.
To Next Page
Need help?
General