Input variables
9
If optional sensors are not used, the settings for them are shown in a different colour and their
parameters cannot be programmed.
Example: Solar control
After selecting the source, you define which information from the source is transferred to the function.
Example: CAN bus analogue
• Measurement - the value captured by the sensor
• RAS mode - the following analogue values will be issued according to the setting of the switch
on the room sensor (RAS, RASPT, RAS-PLUS, RAS-F):
Automatic 0
Standard 1
Setback 2
Standby 3
• Sensor error – digital value, ON if a sensor error occurs
• Network error – digital value, ON if a timeout is active (= error)
When linked to a function, the output variables are displayed for selection.
Use the back arrow to return to the last menu used.
Example: Enable
To Next Page
Loading...