EasyManua.ls Logo

Techno Line WD 2000 - Switching Off Alarm Signal; Snooze Function

Techno Line WD 2000
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
273
Switching off the alarm signal
While the alarm is sounding, press any button
except the “SNZ” button or press hold the “SNZ”
button for 3 seconds to stop the alarm signal.
Snooze function:
While the alarm is sounding, press the “SNZ”
button once to activate the snooze function.
The alarm signal sounds again after already
been set.
In snooze mode, press any button except
the “SNZ” button or press hold the “SNZ”
button for 3 seconds to exit the snooze
mode.
Note:
When the snooze function is set to OFF,
while the alarm is sounding, press “SNZ”
does not have this snooze function.

Table of Contents