14
Spazio Forma
Contents
05092014
F
G
Slide back the two rubber sleeves (F) to uncover the
holes for the two grub screws (G) in the rubber lining.
Tighten up the two grub screws (G) with an Allen key.
Slide the two rubber sleeves back towards the control
panel so that it covers the grub screws and the whole
handgrip.
When the equipment is fully assembled on the floor, check that it is level; if it isn't, proceed with levelling.
1 Technical information
1.1 Equipment identification
1.2 Description of the equipment
1.3 Installation and assembly
1.3.1 Place of installation
1.3.2 Unpacking
1.3.3 Assembly
1.3.4 Levelling
1.3.5 Moving the equipment
1.3.6 Electrical connection
1.3.7 Grounding instructions
1.4 Maintenance
1.5 Easily solved problems
1.6 Technical assistance
1.7 Storage
1.8 Scrapping
2 Using the Spazio Forma
3 Spazio Forma software
To Next Page
Loading...
