Technomark M4 inline - Page 20

Page 20 of 22
TRAÇABILITÉ CRÉATIVE
CREATIVE TRACEABILITY
www.technomark-marking.com
Model from 14/04/2016
TECHNOMARK
3 Allée Michaël FARADAY
Parc d’activités STELYTEC
42400 SAINT-CHAMOND (France)
Tel: +33 (0) 4 77 22 25 91
Fax: + 33 (0) 4 77 22 38 93
E-mail: info@technomark-marking.com
 Error code
 1st level
troubleshooting
 Remedial action
Error 50: Temperature error.
The machine has been in ‘test
position’ for too long and the
motors have been powered up
for too long.
Turn the control unit off for
around ten minutes and
restart.
The ambient temperature is
outside the usage ranges.
Turn the control unit off for
around ten minutes and
restart.
If the problem persists, contact
the After-Sales Customer
Service Team.
Successive marking of a
number of files with a large
number of characters and using
a tight matrix.
Reduce the number of impacts
by using another font.
Reduce the marking speed.
Reduce the marking force.
If the problem persists, contact
the After-Sales Customer
Service Team.
Error code 51: Marking busy.
The requested task cannot be
launched because the machine
is already busy.
Wait for the current task to end
or stop it.
Error 57: TechnoMATRIX
licence error.
The necessary licence is not
present in the control unit.
Contact the After-Sales
Customer Service Team.
Error 58: TechnoLOG licence
error.
The necessary licence is not
present in the control unit.
Contact the After-Sales
Customer Service Team.
Error 59: 16-way line error.
Configuration issue for the file
line with regard to the 16-way
card.
Check the configuration of the
16-way card.
Contact the After-Sales
Customer Service Team.
Error 64: 16- way card error.
Card not detected.
Contact the After-Sales
Customer Service Team.