LLDP Configuration
Sends trap notification to lldp mib database.
Sends trap notification to ptopo mib
database.
Note: Both the no lldp command and the management-ip command can be used
to resume the default management address of the port and the default management
address is the IP address of the VLAN interface that corresponds to the PVID port.
When the corresponding VLAN interface does not exist, the management address is
0.0.0.0.
1.3.10 Configuring the Location Information
The location configuration is used to determine the address of the local machine.
Run the following commands in global configuration mode to configure the
location information:
Enters the global configuration mode.
location elin identifier id WORD
Sets the location elin information, in which id
is the elin identifier number and WORD
stands for the elin information, which ranges
from 10 to 25 bytes.
location civic identifier id
Enters the location configuration mode.
Sets the state’s (provincial) name, such as
shanghai.
Sets the name of a county.
Sets the name of a division.
Sets the name of neighborhood.
Sets the name of a street.
Sets the direction of a main street, such as N
(north).
trailing-street-suffix WORD
Sets the suffix of a small street, such as SW.
Sets the suffix of a street, such as platz.
Sets the street number, such as number 123.
street-number-suffix WORD
Sets the suffix of the street number, such as
number 1/2 of A road.
Sets the landmark, such as Colombia
University.
Sets the additional location.
Sets the information about a resident, such
To Next Page
Loading...
Need help?
General