Techroutes LLDP User Manual

LLDP Configuration
13
Step16
no street-number-suffix
Deletes the suffix of the street number, such
as number 1/2 of A road.
Step17
no landmark
Deletes the landmark, such as Colombia
University.
Step18
no additional-location
Deletes the additional location.
Step19
no name
Deletes the information about a resident,
such as Joe’s haircut shop.
Step20
no postal-code
Deletes the name of a postal office.
Step21
no building
Deletes the information about a building.
Step22
no unit
Deletes the information about a unit.
Step23
no floor
Deletes the information about a floor.
Step24
no room
Deletes the information about a room.
Step25
no type-of-place
Deletes the type of a place, such as office.
Step26
no postal-community
Deletes the name of a postal office.
Step27
no post-office-box
Deletes the name of a postal box, such as
12345.
Step28
no additional-code
Deletes the additional code.
Step29
no country
Deletes the name of a country.
Step30
no script
Deletes the script.
1.3.11 Specifying a Port to Set the Location Information
The following commands can be used to set the location information for a port and
bear the location information in TLV.
Run the following commands in port configuration mode to set the location
information:
Procedure
Command
Purpose
Step1
config
Enters the global configuration mode.
Step2
interface intf-type intf-id
Enters the interface configuration mode.
Step3
location civic id
Sets the location information of civic id.
Step4
location elin id
Sets the location information of elin id.
Run the following commands in port configuration mode to delete the location
information:
Procedure
Command
Purpose
Step1
config
Enters the global configuration mode.
Step2
interface intf-type intf-id
Enters the interface configuration mode.

Techroutes LLDP Specifications

General

Brand	Techroutes
Model	LLDP
Category	Network Hardware
Language	English