Techroutes LLDP User Manual

LLDP Configuration
5
Caution: To ensure the former neighbor information is not lost owing to aging
when receiving next LLDP frame, the timeout time should be longer than the LLDP
packet transmit interval.
1.3.3 Configuring Timer
You can control the interval of the switch to transmit message by configuring the
timer of LLDP.
Run the following command in global configuration mode to configure timer of
LLDP:
Procedure
Command
Purpose
Step1
config
Enters the global configuration mode.
Step2
lldp timer time
Configures the interval of message
transmission of LLDP. The value ranges from
5 to 65534. The default time is 30 seconds.
Resumes the default interval, that is, 30 seconds.
Procedure
Command
Purpose
Step1
config
Enters the global configuration mode.
Step2
no lldp timer
Resumes the default interval, that is, 30
seconds.
1.3.4 Configuring Reinit
LLDP information will be forwarded automatically in two conditions: first, the status
or value of one or more information elements (management objects) change; second,
the sending timer timeouts. A single information change cause the LLDP packet is
forwarded and a series of information change may cause many LLDP frames
forwarded, but a frame can only report one change. For avoiding this, the web
management defines the interval of two continuous LLDP frames. You can control the
interval of the switch to continuously transmit two messages by configuring reinit of
LLDP.
Run the following command in global configuration mode to configure reinit of
LLDP:
Procedur
e
Command
Purpose
Step1
config
Enters the global configuration mode.
Step2
lldp reinit time
Configures the interval of LLDP to
continuously transmit message. The value
ranges from 2 to 5. The default time is 2
seconds.
Resumes the default value of reinit.
Procedur
Command
Purpose

Techroutes LLDP Specifications

General

Brand	Techroutes
Model	LLDP
Category	Network Hardware
Language	English