Techroutes LLDP User Manual

LLDP Configuration
3
DOT3
：
13. MAC/PHY Configuration/Status
14. Power Via MDI
15. Link Aggregation
16. Max Frame Size
MED (TLV of MED is not transmitted by default. LLDP packets with MED TLV
will be transmitted only when LLDP packets with MED TLV are received.)
17. MED Capability (TLV is compulsory if MED TLV is added.)
18. Network Policy
19. Location Identification
20. Extended Power-via-MDI
21. Inventory
（包含
Hardware Revision
、
Firmware Revision
、
Software
Revision
、
Serial Number
、
Manufacturer Name
、
Mode Name
、
Assert ID
）
(3) The end TLV should be the last one in LLDP PDU.
1.2 LLDP Configuration Task List
 Disabling/enabling LLDP
 Configuring holdtime
 Configuring Timer
 Configuring Reinit
 Configuring the To-Be-Sent TLV
 Configuring the Transmission or Reception Mode
 Specifying the Management IP Address of a Port
 Sending Trap Notification to mib Database
 Configuring Show-Relative Commands
 Configuring the Deletion Commands

Techroutes LLDP Specifications

General

Brand	Techroutes
Model	LLDP
Category	Network Hardware
Language	English