Techroutes LLDP - Configuration Example

LLDP Configuration
14
Step3
no location civic
Deletes the location information of civic id.
Step4
no location elin
Deletes the location information of elin id.
1.3.12 Configuring Show-Relative Commands
You can observe the information about the neighbor, statistics or port state
received by the LLDP module by running show-relative commands..
Run the following commands in EXEC or global configuration mode:
Command
Purpose
Show lldp errors
Displays the error information about the LLDP
module.
Show lldp interface interface-name
Displays the information about port state, that is,
the transmission mode and the reception mode.
Show lldp neighbors
Displays the abstract information about the
neighbor.
Show lldp neighbors detail
Displays the detailed information about the
neighbor.
Show lldp traffic
Displays all received and transmitted statistics
information.
Show location elin
Displays the information of location elin.
Show location civic
Displays the information of location civic.
1.3.13 Configuring the Deletion Commands
You can delete the received neighbor lists and all statistics information by running
the following command.
Run the following commands in EXEC mode:
Command
Purpose
clear lldp counters
Deletes all statistics data.
clear lldp table
Deletes all received neighbor information.
1.4 Configuration Example
1.4.1 Network Environment Requirements
Configure LLDP protocol on the port connecting two switches.