LLDP Configuration
PSE MDI power support: support
Port class: PSE
PSE MDI power state: enabled
PSE pairs selection control ability: can not be controlled
PSE power pair: signal
Power Classification: Class 0
Link Aggregation:
Aggregation capability: capable of being aggregated
Aggregation status: not currently in aggregation
Maximum frame size: 1500
------------------------------------------
Total entries displayed: 1
2. TLV Configuration
Configuring switch S1:
Switch_config#lldp run
Switch_config#
Configuring switch S2:
Switch_config#lldp run
Switch_config# no lldp tlv-select system-name
Switch_config#int g0/8
Switch_config_g0/8#no lldp dot1-tlv-select port-vlan-id
Switch_config_g0/8#no lldp dot3-tlv-select max-frame-size
Switch_config_g0/8#
The information of Neighbor B will be displayed on Switch A about 1 minute later,
which is highlighted in red. To differentiate, the information displayed in the basic
configuration of 1.4.3.1 is highlighted in blue.
To Next Page
Loading...