Tecnam P2012 - Page 50

P2012
AIRCRAFT MAINTENANCE MANUAL
tension, or other conditions which may lead to a failure.
Inspect engine parameters sensors and fire detector sensor
for general condition and security of installation.
71-00 Powerplant Inspect engine buffles for proper sealing, condition and
security .
X
71-00 Powerplant Inspect the engine according to Maintenance Manual.
Ref. MM (see
Lycoming MM-
TE0-540-CIA)
71-00 Powerplant Engine Overhaul according to Maintenance Manual.
Ref. MM (see
Lycoming MM-
TE0-540-CIA)
71-30 FireSeals Check engine baffles for correct installation and absence of
chaffing for near items (wiring, pipes, engine mount). Inspect
engine baffles for damage, cracks, dents, kinks. Make sure
that the holes are not ovalized. Check fasteners for
tightening, wear and tear. Inspect silicone rubber for
condition and wear.
X
NOTE:
If MOD2012/057 is installed, Check the westgate drainage fitting for leakage and verify correct
installation and fitting torque. Verify the correct installation of the support and clamps, Refer to ATA 72.
Check support, clamps and fasteners for cracks, damage or deformations.
ATA Aircraft
Zone
Maintenance Task Frequency
A B C D E
PROPELLER
61-00 Propeller Inspect propeller attaching bolts for condition and securing. Check
bolts proper torquing (refer to CMM MT Propeller E-124).
X
61-00 Propeller Check for free movement of propeller levers. Check propeller control
cables full travel and correct operation. Check for restricted
movement, interference or unusual play. Check friction for operation.
X
61-00 Propeller Check the propeller for surface damage (skin cracks, distortion,
dents). Check the bolts torque values. (Refer to ATA and ATA ).
Refer to CMM (see
MT Propeller
Doc.No. E-124)
61-00 Propeller Check the propeller for surface damage (skin cracks, distortion,
dents). Check the bolts torque values. (Refer to ATA and ATA ).
Refer to CMM (see
MT Propeller
Doc.No. E-124)
61-00 Propeller Check propeller governor: inspect for oil leakage at Propeller
governor's surface and at mounting pad. No oil leakage is permitted.
Refer to CMM (see
MT Propeller
Doc.No. E-1048)
61-00 Propeller Propeller overhaul according to Maintenance Manual.
Refer to CMM (see
MT Propeller
Doc.No. E-220)
05-20-00
Page 12
5
th
Edition - Rev. 0
2022, Jan 14