INSTRUCTION MANUAL FOR INSTALLATION, MAINTENANCE AND USE Rev-01
RECTANGULAR BRATT PANS GAS TYPE “BR8G080I - BR8G080I.M” “BR9G090I –
BR9G090I.M” “BR1G120I – BR1G120I.M” “BR1G150I – BR1G150I.M” “BR1G160I –
BR1G160I.M” “BR1G200I – BR1G200I.M”
4.2.1 SWITCH ON, START OF COOKING AND SWITCH OFF
− Here is a list of the procedures for a safe and correct use of the appliance.
− Open the gas valve located upstream of the appliance.
Pilot burner lighting
− Starting from position “⚫” press the gas-valve knob and turn leftwards to position “ “ ; keep the gas-
valve knob pressed . In the electric ignition is automatically switched on, while in the press the pilot burner
ignition button repeatedly. Keep the valve knob pressed for a few seconds after switching on.
− Release the gas-valve knob and control if the pilot burner is lit.
− Repeat the operation if the flame turns off.
In the event of ignition spark plug failure or power failure, pilot lighting can be done
manually through the peephole on the front panel of the machine.
Start cooking - Main burner ignition and temperature regulation
− Once the pilot burner has been lit, turn the gas-valve knob towards right to the positon “ “.
− Turn the thermostat knob (on the gas-valve knob) from the position “0” to the desired temperature between
45° and 295°, and that causes the automatic ignition of main burners.
− The regulation of the thermostat causes the automatic ignition and extinction of the main burner (ON/OFF
regulation); only the pilot flame is lit.
− When the throttle valve knob is turned to the right to position “ “, the main burner is constantly switched
off.
End cooking - Turning the pilot burner off
− Press gas-valve knob and turn to position “⚫” to turn off the pilot burner and prevent the main burner
from lighting.
To Next Page
