INSTRUCTION MANUAL FOR INSTALLATION, MAINTENANCE AND USE Rev-01
RECTANGULAR BRATT PANS GAS TYPE “BR8G080I - BR8G080I.M” “BR9G090I –
BR9G090I.M” “BR1G120I – BR1G120I.M” “BR1G150I – BR1G150I.M” “BR1G160I –
BR1G160I.M” “BR1G200I – BR1G200I.M”
1.5 LAWS, TECHNICAL PRESCRIPTIONS AND DIRECTIVES
When installing the appliance it is necessary to follow and comply with the following regulations:
− current regulations on the matter;
− any hygienic-sanitary regulations concerning cooking environments;
− municipal and/or territorial building regulations and fire prevention prescriptions;
− standards for the use of combustible gas;
− standards for gas-fired systems utilizing on-tap or liquid petroleum gas;
− standards relating to gas-fired cooking appliances and similar equipment used large-scale catering. Safety
requirements;
− standards relating to gas systems for appliances used in professional kitchens and communal facilities
− the regulations of the gas supply company or agency;
− current accident prevention guidelines;
− electricity board regulations concerning safety;
− the regulations of the electrical power supply company or agency;
− any other local prescriptions.
1.6 SPECIAL REQUIREMENTS FOR THE INSTALLATION SITE
− The appliance belongs to the installation class A1 (no direct connection of a chimney of flue exhaust
system is required), so it is very important for the environment in which it is installed to be well-aired and
provided with all the safety openings prescribed for its power.
− In addition, it is good policy to locate the appliance under an extractor hood so that cooking vapours can
be removed rapidly and continuously.
− The gas supply system must be equipped with a rapid on off tap approved for the purpose.
− Current regulations require the installation of a multiple pole switch between the appliance and the
electrical power supply; the switch must have a contact gap of least 3 mm on each pole.
− This appliance requires one water connection. The line must be fitted with an on-off valve.
The electrical isolating switch and the water shutoff valves must both be located near
to the appliance, within easy reach for the user.
Follow the fire prevention regulations very carefully.
To Next Page
Loading...