TECNOMAGNETE ST200F - Personnel Safety and Responsibilities

34
Instruction and maintenance manual
ENGLISH
1.7 Trained personal
• OPERATORS: workers who, after receiving the
necessary instructions, have been authorized by
the owner to operate the controller and the equip-
ment connected to it. Workers with this qualica-
tion must be thoroughly familiar with the content
of this manual.
• ELECTRIC MAINTENANCE TECHNICIAN (ref.
EN60204 paragraph 3.45): this qualication is as-
signed to all personnel specically trained to per-
form operation on electric components, which in-
clude connections, adjustments, maintenance
and/or reparations, and to personnel who is qual-
ied to perform operations inside electric cubicles
and boards. This qualication implies having a
perfect knowledge and full familiarity with the
content of this manual.
1.8 Individual protection means
The personnel referred to in the paragraph above
must always wear suitable protective clothing
and use the protection means generally required
to operate the tool machine on which the Tec-
nomagnete module and controller are installed.
In particular, personnel shall always have to wear
industrial shoes along with ear protection, hel-
mets and goggles, if required.
All personnel should refrain from wearing loose
clothing that could get tangled with moving com-
ponents.
1.9 General safety precautions
The instructions and recommendations provided
below comply with current safety regulations and
imply the obligation of complying with applicable
provisions.
TECNOMAGNETE S.p.A. shall not be responsible
for damages caused to people or equipment
originating from the failure to follow applicable
safety provisions and to comply with the instruc-
tions given below.
All operators are therefore expected to follow the
instructions below and to thoroughly comply with
the safety procedures concerning the installation
and use of the equipment applicable in the coun-
try in which the unit is used.
All ordinary and extraordinary maintenance op-
erations shall have to be carried only after the
unit has been disconnected from the power sup-
ply.
Before connecting the power cable, it is essential
to verify that the line voltage complies with the
one shown on the nameplate of the controller.
All transportation, installation, ordinary and ex-
traordinary maintenance operations performed
on the controller must be carried out only by per-
sonnel with the qualifications stated in Chapter
1.6 and 1.7.
1.10 Behavior during emergency
situations
In the event of emergency, it is always advisable
to follow the procedures outlined in the operation
and maintenance manual of the machine on
which the controller is installed.
In the event of fire, always use the extinguishing
means provided being careful not to use water to
extinguish fires on electric parts.
1.11 Limitations
The unit can be used only for the applications
specified in operating instructions and only in
combination with the equipment and compo-
nents recommended by TECNOMAGNETE S.p.A.