Why is the Tecnoware UPS battery backup time so short?
A short battery backup time on your Tecnoware UPS can occur if the batteries are not fully charged. To resolve this, charge the batteries for at least 7 hours and then check the capacity. It can also happen if the batteries are defective or faulty.
What to do if my Tecnoware EVO DSP PLUS TM 10 KVA UPS shows fault code 43?
Fault code 43 on your Tecnoware UPS indicates that the UPS has been overloaded for too long and has become faulty, causing it to shut down automatically. To fix this, remove excess loads from the UPS output and restart it.
Why is my Tecnoware EVO DSP PLUS TM 10 KVA beeping twice every second?
If your Tecnoware UPS is beeping twice every second, it means the UPS is overloaded. Remove some of the connected devices to reduce the load on the UPS output.
What does fault code 14 mean on my Tecnoware EVO DSP PLUS TM 10 KVA?
Fault code 14 on your Tecnoware UPS indicates a short circuit on the UPS output. Check the output wiring and the connected devices for any short circuit issues.
How to disable EPO function on Tecnoware EVO DSP PLUS TM 10 KVA?
To disable the EPO (Emergency Power Off) function on your Tecnoware UPS, set the EPO circuit in the closed position.
What does warning code 02 mean on Tecnoware EVO DSP PLUS TM 10 KVA UPS?
Warning code 02 on your Tecnoware UPS means that the input neutral wire is disconnected, or the L2 or L3 input fuse is broken. Check and correct the input neutral connection, and replace the fuse if necessary.
What does it mean when my Tecnoware EVO DSP PLUS TM 10 KVA UPS beeps every second?
If your Tecnoware UPS is beeping every second, the external or internal batteries may be incorrectly connected. Check if all batteries are connected correctly.
How to fix a Tecnoware EVO DSP PLUS TM 10 KVA with no display?
If your Tecnoware UPS has no display or indication on the front panel, even when the main power is normal, ensure that the AC input line cable is firmly connected to the input mains. Also, check the input circuit breaker and switch it 'ON' if it is 'OFF'.
Operation when AC input is lost, powering the load using internal batteries.
Indicates a critical error in the UPS, blocking inverter operation.
Provides step-by-step instructions for connecting input, output, and battery cables.
Explains low battery warnings and automatic shutdown/restart procedures.
Describes warning signals, codes, and their meanings.
Explains fault signals, codes, and actions for critical UPS errors.
Instructions for connecting and managing multiple UPS units in parallel.
Steps for connecting multiple UPS units in parallel using specific ports and breakers.
Safety precautions for operators when handling or operating the UPS.
General| Power Rating | 10 kVA |
|---|---|
| Active Power | 9 kW |
| Technology | Double Conversion Online |
| Waveform | Pure Sinewave |
| Communication Interface | RS232, USB, SNMP (optional) |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -15°C to 50°C |
| Cooling | Forced Air Cooling |
| Frequency | 50/60 Hz |
| Battery Type | Sealed Lead-Acid (VRLA) |
| Backup Time | Depends on battery configuration |
| Efficiency | Up to 95% |
| Humidity | 0% to 95% (non-condensing) |
| Protection Features | Overload, short circuit, battery deep discharge |
To Next Page