Do you have a question about the Tecnoware EVO DSP PLUS MODULAR and is the answer not in the manual?
Guidance on choosing the correct placement for the UPS unit.
Procedures for carefully removing the UPS from its packaging.
Instructions on how to safely move the UPS cabinet.
Visual representation of the UPS internal components and wiring.
Details on the different operating modes of the UPS system.
Overview of the control panel's components and functions.
Detailed description of the LCD display's main screens and menus.
A comprehensive list of UPS alarm messages and their explanations.
Details on recorded system events and important setting changes.
Assigning an exclusive identification number to each Power Module.
Details on the communication ports and interfaces of the STS module.
Overview of STANDARD and EXTENDED UPS cabinet series.
Description of the external components and access points of the UPS cabinet.
Step-by-step guide for installing and removing power modules.
Instructions for installing battery modules into the UPS cabinet.
Recommended wire specifications and connection methods for UPS wiring.
Procedure for starting the UPS without AC input power.
Steps for powering on the UPS from a completely powered-down state.
How to properly turn off the UPS in different operating modes.
Procedures for transferring to and from maintenance bypass mode.
Handling low battery conditions and automatic restart capabilities.
How the UPS manages and responds to load conditions, including overload.
Instructions for installing and configuring UPS units in a parallel rack system.
Procedures and precautions for cleaning the UPS unit.
Recommendations for battery maintenance and safety precautions.
Safety measures for operators when the UPS is not functioning normally.
Step-by-step guides for replacing various UPS modules.
Instructions for replacing the UPS air filters.
Statement of compliance with relevant European safety and EMC directives.
Guidelines for the proper disposal of the UPS unit as separate waste.
Safety information and disposal requirements for lead-acid batteries.











