What to do if my Tecnoware UPS shows an OVERLOAD alarm?
If your Tecnoware UPS displays an “OVERLOAD” alarm, it means there's an overload condition. To resolve this, disconnect some of the devices that are causing the overload.
Why my Tecnoware UPS does not turn on?
If your Tecnoware UPS is not turning on, there might be a few reasons: * The ON/OFF button may not be fully pushed. Ensure you press the ON/OFF button firmly. * The batteries might be completely flat. Recharge the batteries for at least 4 hours. * There could be an electronic board failure. In this case, you should refer to Technical Service.
Why is my Tecnoware UPS always in battery mode?
If your Tecnoware UPS is always functioning in battery mode, check these potential causes: * The input mains power cable might be disconnected. Ensure it's properly connected and that there is electrical power. * The input mains fuse could be burnt. Replace the fuse with another of the same type. * There might be black-out conditions, a surge, over-voltage, or low-voltage. Wait until the AC input line returns to normal conditions. * An electronic board failure could be the reason, in which case you should refer to Technical Service.
What does the FAULT alarm mean on my Tecnoware EXA LCD 1.5 UPS?
If your Tecnoware UPS displays a “FAULT” alarm, it indicates a fault condition. Begin by checking if the UPS is in an OVERLOAD condition. If not, you should refer to Technical Service.
Why is the battery life so short on my Tecnoware EXA LCD 1.5 UPS?
If the battery autonomy of your Tecnoware UPS is too short, it could be due to the following reasons: * The battery may not be fully charged. Recharge it for at least 6 hours. * There might be an electronic board failure. In this situation, you should refer to Technical Service.
How to fix Tecnoware UPS when it does not communicate with the computer?
If your Tecnoware UPS is not communicating with the computer, here are a couple of things to check: * The UPS Management Software might be sending a communication error. Verify that the USB (or RS232) cable is correctly connected between the UPS and the computer. * The software might not be correctly installed. Ensure you install the specific software for your computer’s operating system.
Why is my Tecnoware Power Supply always in battery mode?
If your Tecnoware Power Supply is always in battery mode, check the following: * Ensure the input mains power cable is correctly connected and that there is electrical mains present. * Verify the rear ON/OFF switch is in the ON position. * Inspect the input mains fuse and replace it with one of the same type if it's burnt. * If there are black-out conditions, surge, over-voltage, or low-voltage, wait until the AC input line returns to normal.
What to do if Tecnoware Power Supply battery life is too short?
If the battery autonomy of your Tecnoware Power Supply is too short, it might not be fully charged. Recharge the battery for at least 6 hours.
What to do if Tecnoware Power Supply shows OVERLOAD alarm?
If your Tecnoware Power Supply shows an “OVERLOAD” alarm, it indicates an overload condition. Disconnect all devices that may be causing the overload.
To Next Page
General