How to fix Tecnoware ERA PLUS 800 SCHUKO that does not turn on?
If your Tecnoware UPS doesn't turn on, first ensure the ON/OFF button is fully pushed. If that's not the issue, the batteries may be flat. Try recharging them for at least 4 hours. If the problem persists, it might be an electronic board failure.
Why is my Tecnoware ERA PLUS 800 SCHUKO UPS always on battery mode?
If your Tecnoware UPS is always functioning on battery mode, check that the input mains power cable is correctly connected and that there is electrical power. Also, inspect and restore the input mains thermal protection, if needed. If there is a blackout, surge, over-voltage, or low-voltage condition, wait for the AC input line to return to normal.
What to do if Tecnoware ERA PLUS 800 SCHUKO UPS shows 'OVERLOAD' alarm?
If your Tecnoware UPS is showing an “OVERLOAD” alarm, it means the UPS is overloaded. Disconnect some of the connected devices to reduce the load and clear the alarm.
Why Tecnoware ERA PLUS 800 SCHUKO UPS doesn't communicate with my computer?
If your Tecnoware UPS is not communicating with the computer, first check that the USB (or RS232) cable is correctly connected between the UPS and the computer. If the connection is fine, ensure that the UPS Management Software is correctly installed for your computer’s operating system.
To Next Page
General