Chapter 3 Program Tools 40
◎ RUN
(1) RUN (2) ST P Mode
UN PROG. STOP PROG.
or STOP
Mode O
R
>YES >YES
NO NO
↑
ov
↓
M
e the cursor
OK Execute the instruction, then back to main menu
ES BackC to main menu
◎Other u Item
e)
Men s
(1) CLEAR PROGRAM (Clear RAM, EEPROM and Password at the same tim
CLEAR PROG.
YES
>NO
(2) WRITE (save the program (RAM) to the PM05 program spare cartridge)
TE
WRI
YES
>NO
(3) READ (read the program from the PM05 program spare cartridge to SG2 (RAM))
READ
YES
>NO
(1) ∼ (3) Now Press:
↑ ↓
Move the cursor
OK Execute the instruction, then back to main menu
ESC Back to main menu
(4) SET (system
setting)
ID SET tting (00~99) 01
Æ
ID se
REMOTE I / 0 ote I/O Mode ( : n M: Master S: Slave) N
Æ
Rem N one
BACK LIGHT ht mode (√: lw li 10s after pressed.) ×
Æ
Back lig a ays ght ×: light for
M KEEP √:V lat ×: Non- Volatile) √
Æ
M: non-Volatile ( o ile
I/O NUMBER 0
（0~3）
Æ
Expansion I/O module number
I/O ALARM √
Æ
Siren setting when is not available to Expansion I/O Points （√:Yes ×:No）
C KEE
Æ
unter Present Value Keeping（√:Yes ×:No）
P ×
in stop/run switching, Co
Z SET ×
Æ
（√:Yes ×:No）
Setting keypad input Z1-Z4 is available
ote:
nction is only available for keeping M status in RUN mode when power is re-supplied after loss.
N
M KEEP fu
To Next Page
Loading...
