TECO SG2 Series - Page 43

Chapter 3 Program Tools 41
Now Pres :
Note：
① When D elected, ID setting range is 0~7 , which should be continuous。ID=0 default as
Master, ID=1~7 default as Slave
② When REMOTE I/O is selected，the distribution of the remote I/O is as follows:
Master Slave
s
ATALINK is s
Remote Input X1~X12
←
I1~I12
Remote Output Y1~Y8
→
Q1~Q8
(5) RTC SET
R TTC SE V2.0
YY . NN . DD
MO HH : MM
Now Press
eters SEL Begin to input param
Press ‘SEL’
+ ‘← →’
Move the Cursor
SEL then
1. YY=00~99,NN=01~12,DD=01~31
↑ ↓
2.MO⇔TU⇔WE⇔TH⇔FR⇔SA⇔SU⇔MO
3. HH = 00~23 or MM = 00~59
OK Save the Input Data
ESC
1. Cancel the Input Data when press ‘SEL’.
2. Back to Main Menu.
(6) ANALOG SET
A 1=GAIN : 010
Æ
GAIN (0~999)
OFFSET : + 00
Æ
OFFSET (-50~+50)
A 2=GAIN : 010
OFFSET : + 00
Now Press
↑ ↓
1. Move downward the Cursor
2. Switch the setting screen from A1, A2 -> A3, A4 ->A5,A6 -> A7,A8
SEL Begin to input parameters
Press ‘SEL’
+ ‘← →’
Move the Cursor
‘SEL’ +
‘↑ ↓’
1. GAIN =000~999
2. OFFSET=-50~+50
OK Save the Input Data
ESC
1. Cancel the Input Data when press ‘SEL’.
2. Back to Main Menu.
Note: V1 = A1*A1_GAIN + A1_OFFSET …… V8 = A8*A8_GAIN + A8_OFFSET
↑ ↓ ←
c sor
→
Move the ur
SEL Begin to edit.
Press ‘SEL’
and ‘← →
item’ Move the cursor for ‘ID SET
’
Press ‘SEL
and ‘↑
~99 ; I/O NUMBER=0~3
E I/O = N⇔M⇔S⇔N
LI HT ; C KEEP ; Z SET =
×⇔√
ALARM =
√⇔×
’ 1. ID SET=
T ↓’
00
2. REMO
3. BACK G
4. M KEEP; I/O
OK ition Data Confirm the Ed
ESC 1. Cancel the setting when pressed ‘SEL’
to Main Menu 2. Back
SG2 firmware Version