Chapter 4 Relay Ladder Logic Programming 73
Allows the HMI message to include coil number and selected value
(i.e. T1=003 sec).
Provides access to the Analog Display Set dialog for gain and offset parameters
shown below.
The Analog Display Set dialog allows the user to specify a scaling factor (Gain) and an offset for each analog
input value.
A phone number can be displayed on the screen to alert an operator to call for
help.
Note:
The
Phone
Number
field
does
not
dial
a
modem
or
allow
for
a
modem
connection.
Each HMI instruction has a choice of 2 operation modes.
The table below describes each configuration parameter.
Symbol
Description
c
Display Mode (1-2)
g
HMI character output terminal (H1-H8)
To Next Page
Loading...
