20 TS1061 Dual Wiegand Interface Installation Manual
Appendix A: Standalone current draw
The current draw of the standalone board is 73mA from a 12V supply.
The board is configured as follows and is operating normally:
• Standalone operation (no external loads attached)
• The tamper input is sealed (wire link, 0 Ω)
• All four inputs are sealed (10 kΩ EOL resistors)
• The two on-board relays are not active
• USB is not connected
• The RS-485 system LAN is terminated and is connected to a terminated BUS
port of TS1066 Network Access Controller.
To Next Page
Loading...