32
Defaulting the USB Comms Path
You may want to perform a “default” for the USB Comms Path Connection.
Before you begin make sure that the power is still on.
To default the USB:
1. Access the NAC panel PCB.
2. Fit test link 1 (Figure 2 on page 12, item 29) momentarily, and then
remove the link.
On-Board Memory Retention
In the absence of any power source, the on-board capacitor storage will maintain
the real-time clock and system configuration/logs for 5 days under typical
circumstances.
Programming the Network Access Controller
Refer to the TS1067E Network Access Controller Programming Manual for
detailed information about programming the Network Access Controller.
To Next Page
Loading...
