6
Product overview
This manual applies to the following model:
• TS1067E Network Access Controller
Up to 12 Network Access Controllers can be connected to a ChallengerPlus
panel’s RS-485 system LAN. ChallengerPlus panels have two RS-485 system
LANs and can have a total of 24 Network Access Controllers.
The Network Access Controller can operate independently of a ChallengerPlus
panel, depending on its operating mode.
The Network Access Controller, in addition to its Tecom bus, has two RS-485
buses (local LANs) to connect readers for doors, as well as RASs, DGPs, and
Tecom peripherals. There are also four Wiegand reader connections for Wiegand
devices to be attached.
Network Access Controllers provide enhanced access control functionality to the
ChallengerPlus system. This manual describes:
• How to install the Network Access Controller
• How to connect other equipment to the Network Access Controller
This manual is intended for use only by trained Challenger installation and
configuration technicians.
Refer to the MAPROG-TS1067E Network Access Controller Programming
Manual for more details on supported system configurations.
To Next Page
Loading...
