Programmer`s manual
EZE30
Annex A Page 4 BE 948 a www.tecsis.de
Baudrate Settings
In configuration mode it is possible from the front panel to set the baudrate.
The default factory setting is 9600.
RS422/485 Setting
In configuration mode it is possible from the front panel to switch between RS422 and RS485 mode. In RS485 mode the
instrument will turn its transmitter off after sending data allowing other devices to use the bus. In RS422 mode, the
transmitter will remain on.
The default factory setting is RS422.
Address Settings
In configuration mode it is possible from the front panel to set the network address of the instrument to any address
between 0 and 255. Setting the address to 0 will set continuously active mode, where the instrument becomes permanently
active, and will listen and respond to any command on the bus, without the need for an OP xxx command. The default
factory setting is 0.
Auto transmit Settings
In configuration mode it is possible from the front panel to enable auto transmission after power on without sending any
commands. The default factory setting is off.
To Next Page
Loading...