13
When the radio is turned on by the alarm function with radio,
you can short press [POWER] button to continue listening
radio afterwards.
Short press [POWER] again to turn off the radio.
TURN OFF THE ALARM
In radio off mode, short press the [DISPLAY] button to
view the temperature or alarm time.
In radio on mode, short press the [DISPLAY] button to
view the alarm time, temperature, local time, signal
strength/SNR.
DISPLAY MODE
To activate the key lock function, press & hold the [ ]
button; the " " symbol appears on the display. Press &
hold the [ ] button again to unlock.
KEY LOCK FUNCTION
When listening to FM stations via earphones, press the
[FM. ST] button; if the station is transmitted in stereo the
" " symbol appears on the left side of the display.
FM ST. (FM STEREO) BUTTON
8
Method 4: AUTO BROWSE MEMORY
1. Turn on the radio to enter memory
mode. Short press the [VF/VM]
button until the memory position
flashes in the upper right corner
and disappears after 3 seconds.
2. Long press the [VF/VM] button
until "Preset" flashes. The
memory is now being browsed,
staying on each stored station for
about 3 seconds.
3. To stop browsing, press the
[VF/VM] button.
Note: Please read the "Working with Memories" section
before using this function.
flashing
Auto-scan memory with
pre-listening
SLEEP
( )
SINGLE SIDE BAND SSB
1. In any mode, press the [USB/LSB]
button to select SSB reception;
press again to select USB/LSB.
2. Turn the [TUNING] knob to search
stored SSB stations.
3. Press the [BFO] button, when “U” /
“L” flashes on the display, turn the
[TUNING] knob to adjust the
reception.
- " " is for USB.
- " " is for LSB.
When it is off, press and hold the [BFO] button to set the
fine tuning step. (P.15)
Exit SSB: Press and hold the [USB/LSB] button to exit.
SLEEP
SSB fine tuning frequency
To Next Page
Loading...
