How to fix Tecsun PL-310 Receiver that won't turn on?
If your Tecsun Receiver won't turn on, the issue might be due to several reasons: the batteries may be out of power, they might not be installed correctly (check the '+' and '-' signs), or the power button could be locked. Try replacing the batteries with new ones or pressing the unlock button.
Why does my Tecsun Receiver keep turning off?
If your Tecsun Receiver turns off while you're listening, it could be due to low battery power or the sleep timer being activated. Try replacing the batteries or simply turning the radio on again.
How to fix Tecsun PL-310 not storing stations?
If your Tecsun Receiver can't store some stations or stores them with noise using ATS, the frequency of the stations might be too weak, or there could be interference nearby. Try searching for the station manually, lowering the antenna, or moving to another location and trying again.
What to do if Tecsun PL-310 alarm makes noise?
If your Tecsun Receiver alarm only produces noise, it could be due to several reasons: the radio station for the alarm may not be set correctly, there might be no broadcast on that station, or you may be in a location where the preset frequency isn't available. Try presetting your alarm station properly, ensuring there's a radio broadcast in your location, or setting the alarm by buzzer.
Why is Tecsun PL-310 AM reception so poor in the USA?
If you're experiencing poor AM reception on your Tecsun Receiver in the USA, it's because the USA uses a 10kHz step for AM. Turn off the radio and press the [9/10kHz] button to select 10kHz.
How to get more FM stations on Tecsun PL-310 in Japan?
If your Tecsun Receiver is only receiving limited FM stations in Japan, it's because the FM frequency is 76~90MHz for Japan. Turn the radio off, long press the [FM SET] button, and then short press it again to select 76~108MHz.
General| Frequency Range FM | 87-108 MHz |
|---|---|
| Frequency Range MW | 522 - 1620 kHz |
| Frequency Range SW | 1711 - 29999 kHz |
| Tuning Steps SW | 5 kHz |
| SSB | No |
| Type | Portable |
| Tuning Type | Digital |
| Frequency Range LW | 153-513 kHz |
| Tuning Steps MW | 9 kHz |
| FM Sensitivity | 3 uV |
| MW Sensitivity | ≤1 mV/m |
| Audio Output | 3.5 mm headphone jack |
| Output Power | 0.1 W |
| Speaker | Built-in |
| Additional Features | Alarm, Sleep Timer |
Step-by-step guide for setting the clock time.
Instructions for setting the alarm.
Basic instructions on how to turn on and tune the radio.
How to automatically store stations using ATS.
Guide to installing batteries for the radio.
Steps to power the radio on and off.
Instructions for tuning and listening to stations.
How to tune stations using the tuning knob.
How to use auto scan to find stations.
Enter frequencies directly using the keypad.
Automatically store stations on FM, MW, LW, or SW bands.
Store a favorite station manually.
Store stations found via auto search.
Search for and listen to stored stations.
Remove individual or all stored stations.
Automatically scan through stored stations.
Access stored stations directly by number.
Set time using tuning knob and buttons.
Set time directly using numeric keypad.
Set alarm hour, minute, and duration.
Choose between radio or buzzer alarm.
Configure the radio to wake up to a specific station.
Configure the alarm to sound a buzzer.
Temporarily silence the alarm for 5 minutes.
How to stop the alarm when it sounds.
Lock or unlock all keys and buttons on the radio.
Control LCD backlight illumination.
Toggle FM reception between stereo and mono.
Adjust AM bandwidth for improved reception.
Select the FM broadcast frequency range.
Change clock display between 12 and 24 hour format.
Set MW tuning step to 9kHz or 10kHz.
Enable or disable LW band reception.
Disable the audible beeps from button presses.
Control automatic backlight behavior.
Activate or deactivate the battery charging feature.
Use USB for recharging rechargeable batteries.
Guidelines for optimal battery charging and lifespan.
Important considerations for battery usage and maintenance.
How to connect an external antenna for better reception.
To Next Page
